C. Threading the Film
C. Threading the Film
Remove the feed tray and the heatguard. Thread the
¿
lm as
shown in the
¿
gure on the right. Pull the
¿
lm around the idler
rollers as shown. Do not mistake the reinforcing bar for the
Do not mistake the reinforcing bar for the
idler roller
idler roller. Make sure the glossy and dull sides of the
¿
lm
Make sure the glossy and dull sides of the
¿
lm
are as indicated in the diagram
are as indicated in the diagram. Position the threading board
provided.
Turn power and keyswitch to on.
Start the motor by pressing the “Fwd” but-
ton. Feed the threading board and
¿
lm in
between the heat shoes. This will pull the
¿
lm through the rollers until it comes out
the back of the laminator.
Slide the top and bottom
¿
lm rolls from side
to side on the mandrels so that the
¿
lm is
perfectly aligned top and bottom (Note:
overlap will cause the
¿
lm to deposit resi-
due on the heat shoes and rollers, so this
procedure is critical). Replace feed tray
and heat guard.
7
DULL SID
E
SH I NY SID
E
DUL L SI D
E
S H I N Y S I
DE
Laminator.com
www.laminator.com
