A-Series rigging components
2.2 Z5453 AL Hoist connector chain
The Z5453 AL Hoist connector chain is used to connect the lifting
motor(s) to the AL Flying frame using the 1 t shackle. Its length of
53 cm (21") allows enough space for the hang of most 2 t motor
chain containers and avoids any impact on the vertical balance of
the array when suspended from a single pickpoint.
Specification
Lifting chain (DIN EN 818)
2-leg, 6 mm
Grade
10
Nominal length incl. hook
534 mm (21")
Load rating
1.4 t (WLL)
2.3 Secondary safety
WARNING!
Potential risk of personal injury and/or
damage to material!
The secondary safety suspension must be independent of the
primary suspension points and capable of carrying the total system
weight.
The additional safety device must be mounted in a way that the
array is caught by the safety device without any drop and swing in
the event that the primary suspension fails.
The A-Series Flying frame is equipped with two safety points
[S] in
the tie bar of the frame fitted with two 1 t shackles to accept the
d&b Z5454 AL Safety chain or an appropriate equivalent
according to the specifications given in the following chapter
2.3.1 " Z5454 AL Safety chain".
Assembly
1. Before attaching the safety device, ensure the two 1 t shackles
[3] are properly fitted to the frame's safety points [S] as
shown in the graphic opposite.
2. Attach the safety chain and ensure the chains are not twisted
and the hooks
[H] are in the right direction as shown in the
graphic opposite.
2.3.1 Z5454 AL Safety chain
The Z5454 AL Safety chain is supplied with the Flying frame.
Specification
Lifting chain (DIN EN 818)
2-leg, 6 mm
Grade
10
Nominal length per leg incl. hooks
534 mm (21")
Load rating
1.4 t (WLL)
d&b Z5455
AL Flying frame Rigging manual 1.1 en
7
