To attach the bracket to the ceiling, use the holes shown in the
graphic opposite to provide adequate support.
A corresponding fixing template is supplied with these mounting
instructions. Refer to
Chapter 2 "Fixing templates" on page 7.
Preparing the cabinet
The top and bottom panels of the loudspeaker cabinet are each
equipped with a pair of M10 threads. The threads are covered by
dummy caps in cabinet color.
To remove the cap, proceed as follows:
1. Cut out the cap along the recessed spline using an
appropriate cutting knife.
2. Carefully take off the cap and ensure the cabinet coating is
not peeled off.
Attaching the cabinet to the bracket
NOTICE!
Only use the supplied and specified screws
[2], otherwise there a
risk of damaging the threaded inserts.
Always use the spring washers
[3] and U washers [4] to prevent
the bolts from slackening.
Always place the rubber pads
[5] between the bracket and the
cabinet to prevent the cabinet coating from scratching during
assembly and adjustment.
Tools required:
▪ Open-ended spanner/wrench (size #17)
1. Starting on one side, first align one hole of the rubber pad
with one threaded insert.
2. Insert one screw together with the spring and U washers.
3. Align the second hole of the rubber pad with the second
threaded insert.
4. Insert the second screw together with the spring and
U washers.
5. Tighten both screws.
↳This will simplify the attachment of the rubber pad on the
opposite side.
6. On the opposite side, proceed in the same manner.
1.6 Adjustments
To align the cabinet to its desired angle, proceed as follows:
1. Slightly slacken all screws.
2. Align the cabinet to its desired angle.
3. Finally tighten all screws.
d&b Z5410/12 Mounting instructions 1.2 en
6
