Step 2
Step 3
Step 4/5
Step 6
Installing the fixed cable connection
NL4 connection with cover plate
The two NL4 connector sockets of the cabinet's connector panel
are located in a recess to allow the use of the cover plate
[1]
together with NL4 cable connectors, as shown in the graphic
opposite.
Note: Neutrik NL4FC type connectors must be used for this
option.
The cover plate is equipped with two knockout openings to allow
daisy chaining of the loudspeaker.
To use the NL4 connection, proceed in the same manner as
described in the previous section .
2.3. Operation
NOTICE!
Only operate d&b loudspeakers with a correctly configured d&b
amplifier, otherwise there is a risk of damaging the loudspeaker
components.
The applicable amplifiers provide two setups ("Arc" or "Line") for
the Yi8 and Yi12 loudspeakers. These are available in Dual
Channel or Mix TOP/SUB mode.
Selecting the respective Y8 or Y12 setup enables up to two Yi8 or
Yi12 cabinets to be driven by the respective amplifier channel.
Arc and Line setups
The selection of Arc or Line depends on the curvature of the array.
Both setups may be used within one array.
The Arc setup is intended for line array loudspeakers when used in
curved array sections.
The Line setup is used for long throw array sections with three or
more consecutive splay settings of 0°, 1° or 2°. Compared to the
Arc setup, the mid/high range is reduced to compensate for the
extended nearfield.
NL4 cable connection with cover plate [1]
d&b Yi8/Yi12 Manual 1.1 en
7
