Startup
5.3 Controls and indicators
5.3.1 Mains power switch
The on/off rocker switch
[7] is located on the left of the rear panel.
OFF
Mains isolation is not provided. The internal power
supplies are off but stay connected to the mains.
ON
The unit is switched on and ready for operation.
5.3.2 RESET (System reset)
A recessed reset button (RESET
[8]) is located on the rear panel
above the ETH1 network connector.
To prevent accidental system reset, the button is slightly recessed.
To perform a system reset, proceed as follows:
Note: All device preferences will be set to factory defaults
except for the network and fixed device settings.
1. Switch off.
2. Press and hold the «RESET» button using an appropriate pen.
3. While holding the «RESET» button pressed, repower the
device.
↳All LEDs will illuminate red for 1 second while the POWER
LED stays illuminating in green.
4. Release the «RESET» button and briefly press the button again
within 2 sec.
↳The device will reboot.
Further details on the different reset functions are described in the
5D Reference manual which can be downloaded from the related
product page at
d&b 5D Start-up manual 1.1 en
- preliminary -
19
