Dancover GH140040, Manual

Page: 15 / 24

Fig. 18.3 Fig. 18.4
19.
At the front and at the back of the greenhouse above the door and back bar holder (No. 9) polycarbonate-
triangle (400x920 mm) covers by its edges side polycarbonate parts and is tightened to the frame with M5-40
bolts (29), M5 nuts (30), and gaskets (31), and to bar connection angles - with M5-20 bolts (28), M5 nuts
(30), and gaskets (31). Then cut polycarbonate near the frame profile with a sharp knife or a jigsaw, if
necessary (Fig. 19.1
– 19.2).
Fig. 19.1 Fig. 19.2
20.
Apply sealing rubber (36) on the top of channels of side polycarbonate sheets at the top and on the sides
of the front and the rear parts of the greenhouse, and only after that put side and upper parts of polycarbonate
(Fig. 20.1
– 20.5).
Fig. 20.1 Fig. 20.2 Fig. 20.3