10
9
07
Display the wiring for wing
06
Install the Motor and Cowling
Here is a demonstration of the engine installation location and the arrangement of electronic equipment and wires, and you can also
arrange a reasonable location by yourself.
Note: When installing the engine, please adjust the right
pull-down angle 3° and pull-down angle 4°.
The throttle cable is
drilled through
Throttle cable servo installation position
Engine installation display
The thr
ottle cable
contr
ols the ser
vo
Steering gear wiring demonstration
Oil tank position (same as C.G. )
Self-tapping screw
M3x10mm
Self-tapping screw
M2 x10mm
Screw M2*25mm+Nut
Screw M2*15mm+Nut
Screw M2*25mm+Nut
Screw M2*20mm+Nut
X2
Install the cable buckle at
the reserved hole position
shown in the figure.
Install the cable buckle at the reserved hole
position shown in the figure.
Cut the stay wire according to the length, thread it
into the pull ring, and clamp and fix it with aluminum
buckle.
Cut the stay wire according
to the length, thread it into
the pull ring, and clamp
and fix it with aluminum
buckle.
X2
X2
Front of horizontal tail
Back of the horizontal tail
