8
7
04
Install the rudder steering gear and connecting rod
04-1
04-2
04-3
05
Install the elevator steering gear and connecting rod
05-1
05-2
05-3
05-4
05-5
M3*15mm+Self-locking nut
M3*18mm+Self-locking nut
Install the servo seat at the
corresponding position in
the picture, fix the reverse
side with wooden rod and
black tie, and fix it with a
large amount of epoxy
resin adhesive.
Install the servo in the servo
position and fix it with screws.
Install the servo arm on the servo and fix it with screws.
And install the steel wire stay wire.Here are 2 steel wires
controlling the steering rudder.
Place a conduit inside the fuselage as shown
in the figure on the left, the conduit is spliced
by three short tubes. Fix it on the fuselage
frame with a tie.
Install the servo in the servo hole of the horizontal tail and install
the servo arm. The servo wire is led into the conduit placed in the
previous step and led out from the other end. The left and right are
the same.
Install the connecting rod on the servo arm and rotate the
connecting rod to adjust to the proper length
Connect the connecting rod to the servo arm, and tighten the
screws to fix it.
The left and right servo control groups are installed in the same
way.
The other end of the steel wire is connected to the servo arm
of the rudder as shown in the figure.
The two steel wire connecting rods are installed in the same
way, and the wires are kept tight after installation.
Two steel wire connecting rods are installed in an X-shaped
cross.
Black
cable ties
Q2 Wooden rod
Q2 Wooden rod
Assemble the rudder
arm as shown
Alu. buckle
wire penetration
Lead in servo wire
Alu. buckle
Epoxy glue
Epoxy glue
P
P
04-5
wire penetration
Black cable ties
Black cable ties
