1
KIT
机身拼装 Assemble the Fuselage
01-1
配件图仅做参考用，您收到的实物可能因为修改/优化的原因导致与图片有略有不同。
Photos shown here just for reference, the product you received maybe slightly differ from the photos due to
continuous improvement on products.
在两片A1的反面均匀涂抹泡沫胶。
在A2的两侧均匀涂抹泡沫胶。
Spread foam glue evenly on the
reverse sides of the two pieces of
A1.
Spread foam glue evenly on
both sides of A2.
把涂好胶水的A1粘到A2的两侧，粘
贴时对齐边缘及各对应的空位。
Paste the glued A1 to both sides
of A2, and align the edges and
corresponding spaces when
pasting.
把转向舵从机身切下，用模型刀切割转向舵与机身连接处，
切出45度斜面。
Cut the steering rudder from the fuselage, use a model
knife to cut the connection between the steering
rudder and the fuselage, and cut a 45-degree slope.
A1
A1
A2
D1
D2
G2
G1
H1
H2
I
J
C
E1
E2
E3
F
B1
B2
B3
A1-2：机身 Fuselage
B1-2：机翼 Wing
B3：水平尾翼 Horizontal Tail
C：机翼支架 Wing Structs
D1-2：起落架，轮子
Landing Gear; Wheels
E1-3：碳片 Carbon sheet
F：碳杆 Carbon Rod
G2：舵角 Servo Horn
G1：连杆连接件
Linkage connector
H1-2：钢丝连杆
Steel Wire Linkage
J：热缩管
Heat-shrinkable Tube
I：马达座 Motor mount
01-3
机翼拼装 Assemble the Wing
在下机翼B2底面预留槽内嵌入E1碳片，并用泡沫胶把碳片粘固在槽内。
Insert the E1 carbon sheet into the reserved groove on the bottom of the lower wing
B2, and fix the carbon sheet in the groove with foam glue.
把舵机通电回中，并安装
一字型舵臂。然后切掉舵
机支架。
Power on the servo
back to the center, and
install a flat servo arm.
Then cut off the servo
bracket.
把02-1步骤粘好的机
翼翻转，装入舵机并把
舵机线放置到正面。(
如左图安装)此处舵机
不要粘。
Turn over the wing
glued in step 02-1,
install the servo and
place the servo line
to the front. (as
shown on the left)
Do not paste the
servo here.
02-1
02-3
02-2
02-4
02-5
01-2
把下机翼穿入机身下端预留槽内，调整居中并调整好舵机位置，然后用泡沫胶涂抹连接处粘固。
Insert the lower wing into the reserved groove at the lower end of the fuselage, adjust
the center and adjust the position of the servo, and then apply foam glue to the
connection to fix it.
A1
A2
B2
E1
GLUE
GLUE
GL
UE
B1
E1
E1
