4
3
在纸合页缝隙间点入少量CA胶水粘固。
Put CA glue between the gaps of paper hinges
在舵机盖上安装舵机，粘贴
小木块辅助固定舵机。（安
装位置如图所示）
Install the servo on the
servo cover and paste the
small wooden blocks to
fix the servo. (The
installation location is as
shown)
舵机线从机翼内侧预留孔
导出。
The servo line is led out
from the reserved hole
inside the wing.
02
机翼安装
Assemble the Wing
x4
x4
02-1
02-2
02-3
02-6
02-7
02-4
02-8
02-9
02-10
M2*10mm 自攻螺丝
M2*10mm Self-tapping screw
M3*20mm 螺丝+自锁螺母
注意圆环方向如图
Note the direction of the ring as shown
M3*20mm screw+
self-locking nut
M3*10mm 螺丝+自锁螺母
M3*10mm screw+
self-locking nut
M3*15mm 螺丝+自锁螺母
M3*15mm screw+
self-locking nut
02-5
快装接头
EZ connetor
在舵臂上安装快装接头，钢丝连杆 Z 型一端穿入舵角，另一端插入舵臂的快装
接头并锁紧。
Install the EZ connector on the rudder arm, one end of the Z-shape
steel wire penetrates the rudder horn, and the other end is inserted
into the EZ connector of the rudder arm and locked.
注意螺丝上的圆环朝机身方向。
Note that the ring on the screw
needs to face the fuselage.
在副翼预留槽上安装舵角。
（如上图所示）
Install the rudder horns on the aileron reserved slots. (As shown above)
把上下机翼插入连接杆，安装时注意细节 1，2，这两处有机翼锁定的锁扣，需插入到位。
Insert the upper and lower wings into the connecting rod, and pay attention to details 1 and 2 when installing. There
are two locks shown for locking the wings must be inserted into place.
安装好机翼后，把飞机翻
转过来，在左图两个位置
用螺丝锁紧。
After installing the
wings, turn the plane
over and tighten it with
screws in the two
positions as shown left.
M3*15mm 螺丝
M3*15mm screw
前 Front
后 Back
M3*20mm 螺丝+自锁螺母
M3*20mm screw+
self-locking nut
碳管 10*8*460mm
碳管 16*12*810mm
碳管 12*10*810mm
O
B3
B1
O
H
B1
B2
细节 1
Detail 1
细节 2
Detail 2
