INSTALLATION INSTRUCTIONS
B6
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT:
Do not grip or use handle during
installation.
NOTE:
If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE
: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT:
If filler blocks are not used,
case damage may occur from overtightening
screws.
NOTE:
When mounting the
microwave oven, thread
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or
lift oven by pulling cord.
Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
1
2
3
Rotate front of oven
up against cabinet
bottom.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Microwave Oven Top
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw
4
Attach the microwave oven to the top cabinet.
5
Insert 2 self-aligning screws through outer top cabi-
net holes. Turn two full turns on each screw.
Tighten center
screw completely.
6
7
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
6
Tighten center
screw completely.
8
Install grease filters. See the Owner’s Manual
packed with the microwave.
18
