SETTING UP YOUR CHILL N’ TAP
Changing Direction
of the Door “Swing”
6.
Unscrew the upper door hinge
pin from the right side of the
worktop and install it on the left
side of the worktop.
7.
Position the main door back on
the cabinet and push up until the
top hinge pin is inserted into the
top of the door.
8.
Remove the lower support pin
from the door and reposition it
on the lower hinge as shown in
Fig. B
9.
Re-install the lower support pin
the right side of the door.
10.
Make sure to align the door and
cabinet before fastening the low-
er hinge screws to the cabinet.
1.
Lay the unit on it’s back.
2.
Remove the intake/exhaust vent
by removing the three retaining
screws.
(
locations shown in
Fig A
)
3.
Remove the three screws
located on the lower door
hinge.
4.
Pull the door downward until it
releases from the upper hinge
pin.
5.
Remove the plastic screw cap
from the top left hand side and
install it on the top right hand
side of the door frame.
IMPORTANT NOTICE: Before proceeding with the configuration options on this page,
remove keg and the CO
2
cylinder (if installed) from the Keg Cooler. Once complete,
allow the unit to stand upright for 1 hour before putting the unit into operation.
13
Reposition
support pin
Bottom screw position changed
from right to left for new
opening.
11.
Re-install the
intake/exhaust vent.
Fig. A
Fig. B
Lower Door
Hinge
Castor Installation
1.
Lay the unit on it’s side.
2.
Slide the 2
Fixed castors
and the 2
Swivel castors into
the castor slots as shown in
Figure F
.
3.
Secure the casters in place
by using the screws
provided to lock the castors
in position. (
Fig. G
.)
*Please note:
The swivel
castors should be placed in the
front of the unit (towards the
door)
Fixed Castor
Swivel Castor
Castor Slot
The
swivel castors
should be installed in the
front of the unit for easy
access.
Fig. F
Fig. G