4
OPERATING INSTRUCTIONS
TEMPERATURE SELECTION
The refrigerator thermostat dial is located on the
back wall of the refrigerator compartment. The
thicker, darker side of the graduated dial indicates
the coldest setting. The thinner, lighter side of the
graduated dial indicates the warmest setting. The
mid point of the graduated dial should be suffi cient
for regular home use.
This freezer temperature control is located on the
back wall of the refrigerator compartment. The
MAX position indicates the coldest setting. The MIN
position indicates the warmest setting. The mid point
of the slider should be suffi cient for regular home
use.
ICE CUBE TRAY
The appliance is supplied with a fl exible ice cube
tray. Gently twist the tray to remove the ice cubes.
If the ice cube tray is frozen solid, run a little water
over the tray to loosen the ice cubes. Never use
sharp objects to remove the ice cube tray from the
freezer as this can damage the refrigerant lines
inside the freezer.
INTERIOR LIGHT
If the interior light burns out, the LED light strip can
be replaced by following the steps below. Ensure
that the appliance is unplugged before replacing the
light strip.
1. Remove the light cover by pressing upward on
the tab on the bottom and pulling the light cover
downward.
2. Remove the LED light strip by gently pulling it
downward and unplugging it from the port.
3. Plug the new LED light strip into the port and
tuck it into the housing.
4. Replace the light cover by inserting the two tabs
on the top of the light cover into the slots at the
top of the housing and pressing the bottom tab
inward until it clicks into place.
Note:
Contact consumer care for information
regarding receiving or purchasing a new LED light
strip based on warranty eligibility.
MAX
MIN
MAX
MIN
1
2
3
4
