OPERATING INSTRUCTIONS
5
TIMER FUNCTION
Auto On Function
1. Press the timer button until the auto on indicator
light illuminates.
2. Use the up and down arrows to select the
desired amount of time before the appliance
should turn on. The up and down arrows
will add or subtract 30 minutes of time up to
10 hours, then at 1 hour increments up to a
maximum of 24 hours.
3. The time selected will appear on the display
panel and will count down until the appliance
turns on.
Auto Off Function
1. Press the timer button until the auto off indicator
light illuminates.
2. Use the up and down arrows to select the
desired amount of time before the appliance
should turn on. The up and down arrows
will add or subtract 30 minutes of time up to
10 hours, then at 1 hour increments up to a
maximum of 24 hours.
3. The time selected will appear on the display
panel and will count down until the appliance
turns off.
Using Auto On and Auto Off Simultaneously
The auto on and auto off functions can be used at
the same time by fi rst setting one and then the other.
Both indicator lights will illuminate and the display
will count down to the appliance either turning off
or on, whichever function was set fi rst.
Note:
The timer will not cycle the appliance on and
off indefi nitely. The auto on and auto off timers will
function one time and then the appliance will return
to regular functioning.
Turning the appliance off, pressing the default
button on the remote or unplugging the appliance
will clear all memory settings, including the timer.
IONIZER FUNCTION
The ionizer function is a form of air purifi cation that
negatively charges the air. Dust particles, pollen
and other particles in the air cannot pass through
the fi lter when they are negatively charged. This
ensures that the maximum amount of dust and dirt
are removed from the air. Additionally, the ionizer
function helps to remove unwanted odors from the
air.
WATER REMOVAL
There are three ways to remove collected water
from the appliance.
1. Water Bucket
The dehumidifi er will automatically collect
condensed water in the water bucket. When the
bucket is full, the compressor and fan will turn off
and the full bucket indicator light will turn on. The
display will show “P2”.
To empty the bucket, gently remove it from the
appliance by gripping both sides and pulling
outward. Be cautious when removing the bucket, it
will be full and can be heavy.
Do not place the water bucket directly on the fl oor.
The bottom of the bucket is uneven and it will fall
over and spill water.
Empty the bucket and replace it in the appliance.
The dehumidifi er will not function without the bucket
installed.
Note:
When removing the bucket, the pump arm
for the drain pump may fall down. It must be gently
pushed upward back into the correct position before
replacing the bucket.
