4
Care and Maintenance
•
Turn the temperature control to the “OFF” or “0” position, unplug the unit and remove the food and interior accesso-
ries.
•
Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking
soda to a quart of water.
•
Wash the baskets and interior accessories with a mild detergent solution.
•
The outside of the unit should be cleaned with mild detergent and warm water.
Caution:
Failure to unplug the appliance could result in electrical shock or personal injury.
CLEANING THE APPLIANCE
Troubleshooting
Occasionally, a minor problem may arise, and a service call may not be necessary - use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or
Danby’s Toll Free
Number
for assistance.
Tel: 1-800-26- (1-800-263-2629)
PROBLEM
POSSIBLE CAUSE
SOLUTION
Does not work
•
No power to unit
•
Power cord is unplugged
•
Wrong voltage is being used
•
Check connection of power
cord to power source
•
Plug in the unit
•
Use proper voltage
Refrigerator runs continuously
•
Temperature set too low (too
cold)
•
Door is not closed
•
Hot food inserted
•
Door opened too long or too
often
•
Close proximity to heat
source or direct sunlight
•
Set temperature higher
(warmer)
•
Close door securely
•
Be sure food is at room tem-
perature before inserting
•
Minimize door openings/du-
ration
•
Do not place unit close to
heat sources or direct sun-
light
Internal temperature not cold
enough
•
No power to unit
•
Power cord is unplugged
•
Temperature control set too
high (too warm)
•
Door is not closed
•
Hot food inserted
•
Door opened too long or too
often
• Air
fl ow obstruction
•
Wrong voltage is being used
•
Close proximity to heat
source or direct sunlight
•
Check connection of power
cord to power source
•
Plug in unit
•
Check setting and change as
needed
•
Close door securely
•
Be sure that food is at room
temperature
•
Minimize door openings/du-
ration
•
Allow room for air to circulate
around the unit
•
Use proper voltage
•
Do not place unit close to
heat sources or direct sun-
light
