OPERATING INSTRUCTIONS
KEY PAD FEATURES (cont’d)
ENERGY SAVER:
Automatically cycles the fan on and off while the compressor is not in use. This function
is available in Cool, Dry, and Auto modes (only Auto-Cool and Auto-Fan modes). The fan will continue to run
for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals,until
the room temperature is above the set temperature. At this point, the compressor turns back on and cooling
restarts.
TEMP / TIMER CONTROL:
Used to increase or decrease the Temperature setting in 1°C / 1°F increments,
and Auto-Timer On/Off settings in 30min./1hr. increments.
Note:
This appliance allows you to select the
temperature scale to be displayed in either “Celsius” or “Fahrenheit” according to your preference.To change
the temperature scale displayed on the electronic display, press both the “Temp/Timer” adjust arrows simulta-
neously to alternate between Celsius and Fahrenheit.
CHECK FILTER:
The adjacent indicator light will illuminate as a reminder to clean the air conditioner fi lter
(see page 11). Once the fi lter has been cleaned and replaced, depress the Check Filter button in order to
resume operation.
SLEEP MODE:
In this mode, the selected temperature will increase (when in cooling mode) by 1°C/2°F
one half-hour after Sleep mode has been selected. The temperature will then increase by another 1°C/2°F
after an additional half hour. This new temperature will be maintained for 6 hours before returning to the
originally selected temperature. This ends the Sleep mode and the unit will continue to operate as originally
programmed. The Sleep mode program can be cancelled at any time during operation by pressing the Sleep
button again.
AUTO-TIMER:
Used to initiate the Auto On/ Auto Off timer.
When the air conditioner is off (Auto-On feature):
1)
Press the Auto-Timer button once and the adjacent Auto-On indicator light will illuminate.
2)
Use the Temp/Timer control cursors to select a delayed ON time of up to 24 hours.
3)
Select the appropriate mode under which you want the unit to operate (Auto-Cool-Dry-Fan Only).
4)
Select the fan speed setting.
5)
The time you selected will appear in the LED display.
When the air conditioner is on (Auto-Off feature):
1)
Press the Auto-Timer button twice and the adjacent Auto-Off indicator light will illuminate.
2)
Use the Temp/Timer control cursors to select a delayed OFF time of up to 24 hours.
3)
The time you selected will appear in the LED display. The Auto-On and Auto-Off timer features can operate
during the same program by defi ning the Auto-Off parameters immediately after the Auto-On parameters.The
Auto-Timer may be cancelled at any time by turning the unit On/Off.
For example, if you want to turn the unit on one hour later, to operate for one hour and then stop, set Auto-On
“1” and Auto-Off “2”.
Note:
This is a “one-shot” timer.
It does not continue to cycle on and off. It will turn the unit on (
if
set by the
user) ONE time. It will turn the unit off (
if
set by the user) ONE time. If you require the unit to turn on/off again
automatically, then you must set the timer again.
9
