08/05
Assembly
4.1
Adjusting the limit switches
Note circuit diagram of the limit switch.
Fig. 4: Limit switches
No. Name
1
Clamping ring
2
Protection pipe
3
Mounting bolt
4
Limit switch
1.
Detach the corresponding clamping ring (1) at the protection pipe (2) by loosening the
mounting bolt (3).
2.
Move the limit switch (4) into the desired position.
3.
Clamp the ring (1) by tightening the mounting bolt (3).
4.
Check the position of the limit switch (4) by turning the screw manually.
5.
If necessary, repeat the procedure.
MULI
®
- JUMBO
®
33
