DANA SPICER Torque-Hub S6B, Assembly And Disassembly

Page: 14 / 24

9
HUB-SPINDLE SUB-ASSEMBLY
14B. Place a bolt in the hub’s bolt circle. Place a torque wrench on the bolt and pull the
torque wrench smoothly toward you at approximately 3.5 R.P.M. Initial rolling torque
should be 25-35 inch.-lbs. See Diagram 1 on page 11 for correct position of torque
wrench.
15B. Spin the hub and re-torque until there is a final rolling torque reading of 5-10 in.-
lbs. higher than the initial rolling torque reading. [Example: Initial was 30 in.-lbs. Final
should be 35-40 in.-lbs.] Now go on to step 17.
17. Now that the rolling toque is correct, bend the aligned tang of lockwasher (1J) into
the slot in locknut (1K).
18. Stake the locknut (1K) in four equally spaced places 1/8 inch from the inner edge
of the locknut.
CAUTION : Wear safety glasses during this step:
19. Using retaining ring pliers, place retaining ring (1L) over locknut (1K) .
20.
Apply a light coat of “Never-Seize” to
pipe plug (1N) . tighten pipe plug (1N) into
the pipe plug hole in side of hub (1G) .
21.
Apply a light coat of “Never-Seize” to
pipe plug (1P) . Tighten pipe plug (1P) into
the pipe plug hole in side of hub (1G).
22. At this point the hub-spindle sub-assembly is complete.