Installation Guide
CONFIDENTIAL
TG-0057_19 TM4 SUMO HD CO300-A1_A2_A2.5 Installation Guide
© Dana TM4 inc., 2013-2020
Page 12 of 42
2020-11-20
4 Installing the MCU in the vehicle
The following sections describe how to install the MCU in a vehicle. The final installation sequence should
be defined by the integrator according to the type of application.
Read these general safety warnings before installing the CO300HV MCU.
WARNING
Mishandling of this product may damage the product and/or cause injury or death.
•
Do not attempt to open the MCU for repairs; in case of damaged casing or suspected product
malfunction, contact TM4.
•
Use only recommended points to secure the MCU.
•
If using chains or other lifting tools, ensure they do not touch or put pressure on any part of the
product exterior (surface, connectors, and/or cables).
4.1 Planning to install the MCU
•
Ensure that everyone coming into contact with the MCU has received full training and has read all the
safety warnings in this guide.
•
Follow all instructions in this guide on how to install the MCU.
•
Call TM4 Customer Service if in doubt (see Section 5 for contact details).
4.1.1
Respecting CSC and MKC markings on interface drawings
Before installing the product, refer to any CSC and MKC markings on the product interface drawing [11].
These markings highlight areas that may potentially impact product safety, operation or longevity if proper
instructions are not followed:
•
CSC
is used to indicate Critical/Safety Characteristics with specific instructions that must be followed in
order to avoid potentially dangerous, hazardous or non-regulatory situations.
•
MKC
is used to indicate Major Key Characteristics with specific instructions that must be followed in
order to avoid major inconvenience to the user. Items marked with MKC do not, however, represent a
hazard in terms of operational safety.
4.2 Preventing damage to the MCU
These subsections give information on how to prevent damage to the MCU.
WARNING
Mishandling of this MCU may damage the product and/or cause injury or death.
When manipulating this product:
•
Ensure that the MCU and the motor are attached to separate supports or brackets.
•
Do not modify any part of the MCU.
•
Do not apply any external load to the casing of the MCU.
