Dan D'Agostino MLife, Owner'S Manual, Page: 12 / 30

D’Agostino MLife manual / page 12
DC cable for power supply
The MLife is supplied with a special multiconductor DC cable that interfaces the power
supply with the main chassis. To connect the cable, simply align the connector in the
jack on the back panel and push it into place. Be sure to hook up the DC cable before
you connect the power supply to the AC outlet, and disconnect the AC before you
remove the DC cable.
AC cord
The power supply is supplied with a high­quality AC cord tipped with a 15­amp IEC
connector at the MLife end and a three­conductor AC plug at the other end. You may
use a different power cord with the Momentum if you wish, as long as it is tipped with a
15­amp IEC connector and a three­conductor AC plug. After the speaker, interconnect
cables, and power supply connector cable are connected, push the IEC connector on
the power cord into the IEC jack on the MLife. Do not plug the MLife or any other Dan
D’Agostino Master Audio Systems product into a power strip or power conditioner.
Headphone jack
This 1/4­inch jack allows connection of headphones to the MLife. Headphones with a
1/8­inch plug may be connected using a 1/8­inch to 1/4­inch adapter. To activate this
output, press the Headphone button on the front panel or the MLife app. This will mute
the speakers. To restore sound to the speakers, press the Headphone button again.
IR control input
This is an IC5­type 3.5mm input for a remote control signal. It can be used with third­
party automation and IR repeater systems.
To activate this input, plug in the cable from the third­party system. Now plug the power
cord back into the power supply and push the Standby button on front of the MLife. The
unit will now receive commands from the home automation system.
RS­232 input
This DB9­type input allows the MLife to be controlled by home automation systems that
use RS­232. Consult your D’Agostino dealer for more information.