INSTALLATION:
1.
Remove visor clips nearest to rearview mirror. Note: for lightbars with 2 piece shrouds, both visor clips must
be removed.
2.
Place rubber gasket over metal edges of flashback shield by sliding the edge of the flashback shield into the
open edge of the gasket.
3.
Secure each mounting bracket to the metal frame using the provided ¼ ”x20 hex head bolts. The bottom of
the metal has two holes on each side. Insert the hex head bolts through the bottom holes on each side to
fasten the frame to the mounting brackets.
4.
Place lightbar in position above mirror and reattach visor clips.
5.
Conceal the black wire harness by pushing it up into the headliner.
Wiring Guide:
Red
:
Positive (+) 12VDC
Black:
Ground (-)
White
:
Mode 1 Activation, steady Positive (+)
Yellow
:
Mode 2 Activation, steady Positive (+)
Blue
:
Pattern Selection, Momentary ground (-)
Green
*
: Takedown Activation, steady Positive (+)
*
When Takedowns are not activated, modules will flash along with the other LED Modules.
Wiring Configuration:
To power up the unit, extend the
RED
(+) wire to the vehicle’s positive (+) post on the battery, and extend the
BLACK (-) wire to the ground post. Be sure to fuse the
RED
(+) wire appropriately.
To activate Mode 1, apply constant positive (+) 12VDC to the
YELLOW
wire.
To activate Mode 2, apply constant positive (+) 12VDC to the
WHITE
wire. NOTE: Mode 2 will override
Mode 1 when both modes are activated.
To activate Takedowns, apply constant positive (+) to the
GREEN
wire. NOTE: When Takedowns are not
activated, modules will flash along with the other LED Modules.
To change patterns on either mode 1 or 2, activate the lightbar and attach the
BLUE
wire to Ground (-)
momentarily.
