3
NEW MACHINE CHECKOUT
Before a emp ng to use or operate the spreader it is important to be thoroughly familiarized with the contents of
this manual. Then the machine should be checked using the following check list:
1. Ground drive re in
fl
ated to 22 PSI. Tires in
fl
ated to manufacturing speci
fi
ca ons.
2. All bearings lubricated and ghtly mounted with collars securely locked.
(See lubrica on schedule page 5.)
3. Conveyor chains, drive chain & ground drive chain adjusted to correct tension. Conveyor chain should
be
fl
ush or just below the bo om of the trough in the area approximately 2’ behind the front roller.
4. Sprockets ghtened & in proper alignment.
5. Inspect en re machine for loose bolts, especially in the spinner assembly and drive line area.
6. Distributor fan blades set properly. (See spread adjustment and applica on rates)
7. Place 1/2” material on top of chain, lower gate to material, set pointer at 1”.
8. Tighten wheel bolts daily – 95 foot pounds single axle spreaders.
9. Check drive line for ease of opera on by turning sha by hand. If the foregoing inspec on reveals
that addi onal lubrica on or adjustment is required, refer to the proper sec on of this manual for
detailed instruc ons.
10. Ground drive wheel and universal joint shear pins in place and ght.
11. Check both spinner gear boxes for oil;
fi
ll to level of pipe plug with SAE No. 90 non-detergent oil.
Summary of Contents for MOBILITY 800
