OPERATING INSTRUCTIONS
Single Step Cutting
DO NOT FORCE THE TOOL! It will do the
job better and safer at the rate for which it
was designed.
Use original DALTOOL® wet cutting blades
only.
●
Loosen the Adjustable Cutting Guide
retaining knob.
●
Position the Adjustable Cutting Guide to
desired cutting length.
●
Tighten the retaining knob.
Place the tile against the Ruler/Stop
and Cutting Guide.
●
Turn the motor ON.
●
Verify proper coolant flow on both sides
of the blade.
●
Perform the cut.
●
Turn the motor OFF when work is
complete.
Multiple Step Cutting
During this sawing process the saw is posi-
tioned at the desired height and moved back
and forth through the material to be cut until
after a number of steps it is completely cut
through.
●
Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjustable
stop.
●
Position the cutting head at the desired
height
●
Hold the material with one hand while
making sure your hand is free from the
cutting blade.
●
Perform the cut. This process must be
repeated until the material has been
totally cut through.
●
Turn the motor OFF when work is
complete.
45˚ Miter Cutting:
The DALTOOL® 1048BrS Tile Saw is desig-
ned to perform 45˚ Miter Cuts without addi
-
tional tools.
●
Loosen the 2 handles on either side of
the machine.
●
Tilt the cutting head into the 45˚ position.
●
Fasten both handles.
●
Place the tile on the cutting table in the
desired position.
●
Hold the tile down with one hand. (Keep
hand away as far as possible from the
cutting blade)
●
Turn the motor ON.
●
Verify proper coolant flow on both sides
of the blade.
●
Perform the cut.
●
Turn the motor OFF when work is
complete.
PAGE 14
DALTOOL 1048BrS OPERATING MANUAL V02/2008R1
Cutting Guide
Retaining Knob
