Dalsa Spyder 3 GigE SG-10-01k40-00-R, User Manual

Page: 117 / 121

Spyder 3 GigE User’s Manual
DALSA 03-032-10158-09
117
Revision
Number Change Description
Hz. Note concerning FPN and PRNU coefficients’ factory calibration change
from 3.5 kHz line rate to 5 kHz.
Section 4: Electrical interface information, including EMC requirements and
shielded cable information, added to optical and mechanical considerations.
Section 6.3 Product Support form: Control signals section changed to reflect
GigE requirements.
Section A4.1 Ethernet test pattern revised. Ethernet test pattern only available
using the QuickCam application.
Section A4.7 Returning Camera Settings: GCP Screen updated.
Appendix B: EMC Declaration of Conformity: “Pending” stamp removed.
Products covered by the declaration and EMC requirements listed.
05 -Page 24, mechanical updated. GPIO connector corrected to female connector
from the incorrect male connector.
-Page 25, Table 5: GPIO Connector Pinout, inputs and outputs corrected to read
0 to 3, and not 1 to 4 as stated in earlier versions.
-"Preliminary" stamp removed from user manual.
06 -Revised dynamic range: Up to 1400 : 1.
-Added dark current clear information and setting the readout mode (srm)
command description to Appendix A.
-Revised camera mechanical, page 38. Ethernet connector reversed, revised
dimensions for connectors on back plate.
-Revised the gcp command results screen to include the srm command.
-ASCII reference revised to include srm command.
07 Revised performance specifications, as shown, page
337H
7:
PRNU ECD
Uncorrected Local
Uncorrected Global
Corrected Local
Corrected Global
%
%
DN p-p
DN p-p
8.5%
10%
80
80
8.5%
10%
80
80
8.5%
10%
95
95
1
GPIO Connector section revisions, page
338H
26:
-Revised GPIO connector. Connector pinout revised: pins 2, 4, 7, 12, 14, and 15
revised to "LVDS (negative)."
-TTL Input schematic: Input voltage revised to maximum of low 0.66 V;
minimum of high 2.6 V.
-TTL Output schematic: Output voltage revised to maximum of low 0.55 V @
32mA; minimum of high 3.8V @ 32mA.
-GPIO Isolation section added.
08 -RoHS compliance designation added to this user manual.
-Responsivity, random noise, SEE, and NEE specifications revised. Previous
specifications cited 8 bit numbers, not the correct 12 bit. Page
339H
7.
-Responsivity graph revised, page
340H
13.
09 - Note added to Sensor Shift section: You can control the CCD shift direction
through the serial interface. Use the software command scd to determine
whether the direction control is set via software control or via the Camera Link
control signal on CC3. Refer to the CCD Shift Direction section of this manual,
page
341H
57, for details.
-Get scd description, page 95, revised to include the following:
When
scd 2 is selected, the following is returned:
2 = External direction control: currently forward (CC3 is high).
3 = External direction control: currently reversed (CC3 is low).