«CamName» User’s Manual
23
DALSA Corp.
03-32-00253-13
4
Troubleshooting
The information in this chapter can help you solve problems that may occur during the
setup of your camera. Remember that the camera is part of the entire acquisition system.
You may have to troubleshoot any or all of the following:
•
power supplies
•
cabling
•
framegrabber hardware & software
•
host computer
•
light sources
•
optics
•
operating environment
•
encoder
Your steps in dealing with a technical problem should be:
1.
Follow the troubleshooting flowchart (Figure 9 in this chapter).
2.
Try the general and specific solutions listed in sections 4.1 and 4.2.
3.
If these solutions do not resolve your problem, see section 4.3 on getting technical
support.
4.1 General Solutions
Connections
The first step in troubleshooting is to verify that your camera has all the correct
connections. Follow the troubleshooting flowchart shown in Figure 9.
Power Supply Voltages
Check for the presence of all analog and digital voltages at the camera DB25 connector.
Verify that all grounds are connected together at both camera and power supply.
EXSYNC
EXSYNC must toggle (300 Hz min.). The camera will not output lines if EXSYNC is
restricted to logic HIGH or logic LOW. Using an oscilloscope, check the camera end of the
control signal cable to verify that EXSYNC and EXSYNCB toggles.
Summary of Contents for PIRANHA CL-P1
