Dalsa PC-30-02K80, User Manual

Page: 83 / 96

Piranha Color Camera User’s Manual 83
DALSA 03-032-10211-01 5/9/2007
Mnemonic Syntax Parameters Description
+10 dB
set analog offset sao t i Sets the analog offset.
t =
tap selection,
1
to
4
depending on
color selected, or
0
for all taps.
i
= Offset value in a range from
0
to
255
(12-bit LSB). Set to three time
RMS noise at high gain.
set averaging horizontal sah i Sets the number of horizontal pixels to
average. Available values are
1
(factory
settings) and
2
.
set baud rate sbr i
Set the speed of camera serial
communication port. Baud rates:
9600
,
19200
,
57600
, and
115200
. Power on default: 9600.
select cable scb i Sets the cable parameter. Increase this
value for longer cables and decrease
the value for shorter cables.
set color correction scc i1 i2 i3 i4 Set how three video streams from the
CCD are combined to provide the four
(red, green, blue, and luminance)
output streams. Use SCL to select the
color, RGB for luminance, to modify.
i1 = Offset (0 to 4095)
i2 = Red multiplier (-8192 to 8191)
i3 = Green multiplier (-8192 to 8191)
i4 = Blue multiplier (-8192 to 8191)
Multipliers are divided by 4096 to get
the actual factor.
set ccd direction scd i Sets the CCD shift direction where:
0 =
Forward CCD shift direction.
1 =
Reverse CCD shift direction.
2 =
Externally controlled direction
control via CC3.
set color scl s rgb/r/g/b
set digital offset sdo t i Subtracts this value from the video
signal prior to FPN correction.
t
= tap selection,
1
to 4 depending on
color selected, or
0
for all taps.
i
= Offset in a range from
0
to
4095
.
set exposure mode sem m Sets the exposure mode:
2 =
Internal line rate and exposure
time set using commands
ssf
and
set
3 =
External SYNC, maximum
exposure time
4
= Smart EXSYNC
5
= External SYNC and PRIN
6
= External SYNC, internal exposure
time set using SET command
7 =
Internal line rate, maximum
exposure time. Factory setting.
set exposure time set f Sets the exposure time. Refer to the
camera help screen (
h
command) for