Dalsa Pantera DS-21-01M60, User'S Manual And Reference

Page: 60 / 62

60 Pantera 1M60 and 1M30 User’s Manual
DALSA 03-032-10033-09
Revision Number
Change
Description
Springs address on page 2. Exposure Mode default
changed from 7 to 2. Updated Mode 7 timing diagram on
page 22. Was incorrect. Figure 17 (Housing Dimensions)
updated to show camera thickness change
Rev 07 Change Theta-z (rotational tolerance) in Performance
Specification table (pg 7) from 1.0 to 1.25 degrees.
Revised 'Rotation WRT Bottom of Camera' in Mechanical
Interface drawing on Pg 35 from .6 to 1.25 degrees.
Rev 08 Updated
sbm
command in section 3.9 Increasing
Sensitivity with Binning, All Available Commands table
in Appendix B, Table 11: Pantera 1M60 Binning vs. Speed
using Dual Output and Exposure Control Enabled, , and
Table 12: Pantera 1M60 Binning vs. Speed using Dual
Output and Exposure Control Disabled. Vertical and
horizontal binning factors no longer need to be identical.
Rev 09 -Revised sensor alignment, page 8, from ±0.30mm to
±0.350mm.
-Updated camera performance specs figures 3 (Typical
Normalized Noise vs Ambient Temperature), 4 (Typical
Dark Offset vs Temperature), and 5 (Typical FPN vs
Temperature), pages 9 and 10.
-Reference to the LED on camera back, changed to "status
LED."
-Revised references to specific pages on the DALSA
website.
-Changed heading "Online Help" to "Help Command,"
page 17.
-Revised lens mount measurement, page 36, from ±0.3mm
to ±0.3mm.
-References to "CCDs" in the Preventing ESD Damage
section, page 37, changed to "cameras."
-Rewrote Verify Temperature section, page 42.
-Added "If including images, save them in the .tiff
format." to the Product Support section, page 44.
-"Preliminary" stamp removed from doc.
-Removed "True Frame" references.
.