4
Channel 6=Channel 6 PWM output
Channel 7=Channel 7 PWM output
Channel 8=Channel 8 PWM output
Channel 9=RSSI output (Capable to set output mode)
Channel 10=PPM output (Capable to set output mode)
Above each pin’s function was defaulted by receiver, which is capa
ble to reset to change its function, For example , set the channel
10 to SBUS output, details of setting process please refer the functi
on diagram.
Note :To keep the 433 signal on the best condition, we recommend
setting the transmitter and receiver’s antenna vertical to the ground
,the receiver’s antenna can be set up by using a plastic beverage
straw or a chopstick (Do not using the carbon stick or any metal r
elated sticks)
Setting process of common used function
Note: Before frequency binding or setting fail-safe transmitter must
be accessed in one of PPM,PWM or SBUS signal successfully.
(1)
Single receiver’s frequency binding process: keep press receiver’s
button until blue light flashing release it, then power supply to rec
eiver (when transmitter’s blue light stop flashing, receiver’s red lig
ht on, frequency binding success )
