DMX 2400
www.dallmeier.com
20
7.2.2
Without RAID System
The devices of the DMX series can be operated without a RAID system as well. When a
hard disk drive failes, the corresponding recordings are lost. But recording is continued on
the remainingg hard disk drives. The replacement of the hard disk is not possible during
operation.
In the case of service it is recommended to make a backup of essential recordings first.
After replacing the hard disk drive, all tracks have to be initialized and in this process all
recordings will be lost. The settings of the device are completely preserved.
Note that
•
new HDDs must be tested and released for the installation by Dallmeier (HDD-Whitelist
in the partner forum).
•
new HDDs should not be formatted and not be partitioned.
Recommended procedure in the case of service
In the case of a hard disk failure the recording is continued.
Identify the defective hard disk drive (
XXX
).
Fig. 7-6
Shut down the device.
Disconnect the device from the power supply.
Replace the hard disk (see bellow).
Note that the capacity of a new HDD may not differ from the exchanged HDD.
Connect the device to the power supply.
Note the messages displayed during the boot process.
The initialization of the tracks is required after the boot process is completed.
NOTICE
Data loss!
During the initialization of the tracks all recordings have to be deleted.
Log on to the configuration interface as described above.
Open the
Harddisk Management
dialogue via
System
>
Recording
>
Harddisk
Management
.
