DDZ40(10)(20)-YY/HS/HD
www.dallmeier.com
136
14.3.7.2 Privacy Zone
To ensure privacy protection and compliance with laws and regulations that prohibit cer-
tain locations from being monitored and/or recorded, the
PRIVACY ZONE SETUP
allows
you to hide (mask) up to 8 user-definable areas in the camera (including up to 4 polygo
-
nal areas at the same time).
Note that when a defined Privacy Zone is active, the Flip feature of the camera is disa
-
Also note that the accuracy of a defined Privacy Zone is always dependent on its size.
If a set Privacy Zone does not exactly mask the required area, the defined Privacy Zone
area was too small.
In this case, increase the size of the respective Privacy Zone to optimize the internal
processing algorithms.
PRIVACY ZONE SETUP
NO TITLE METHOD COLOR ZT
01 None BLU OFF
02 None BLU OFF
03 None BLU OFF
04 None BLU OFF
05 None BLU OFF
06 None BLU OFF
07 None BLU OFF
08 None BLU OFF
Save and Exit
TITLE
Up to 16 characters
METHOD
Privacy Zone 1 – 4:
POLYGON
,
V.OFF
(Video off),
None
(Privacy Zone inactive)
Privacy Zone 5 – 8:
BLOCK
,
V.OFF
(Video off),
MOSAIC
,
None
(Privacy Zone inactive)
COLOR
Only effective with
METHOD
>
BLOCK
and
POLYGON
BLU
(Blue),
PUR
(Purple),
RED
,
YEL
(Yellow),
CYA
(Cyan),
GRN
(Green),
MAG
(Magenta),
WHT
(White),
GRY
(Grey)
ZT
Zoom Trigger (
OFF
,
ON
)
ZT
>
ON
: Privacy Zone will only be enabled when reaching or exceeding the
zoom factor specified here.
ZT
>
OFF
: Privacy Zone is always enabled (if active).
Select an item (1 – 8) from the Privacy Zone list.
Select the name field (
TITLE
) of the Privacy Zone.
Click
iRiS +
to edit the Privacy Zone title (see section “
Select the
METHOD
for the masking of the Privacy Zone.
Pay attention to the available methods for each Privacy Zone item, as described above.
Select the number (
NO
) of the Privacy Zone item.
Depending on the selected method (
POLYGON
, or other method), there are two different
procedures for defining the Privacy Zone (see below).
