dallmeier DDF3000AV4-DN, Installation And Configuration Manual

Page: 21 / 40

21 Dallmeier electronic
DDF3000AV4-DN / DDF3000AV4-D

Connect the camera via terminal ( I , see Fig. 5-5) or UTP port ( H ) to an appropriate power
supply unit and a CVBS or UTP device. Ensure the correct pin assignment.
NOTE
For pinout information see chapter Pinout information .

Select the relevant video output type using the UTP/BNC switch ( F ).

Connect the power supply unit to the mains socket.

If necessary, connect the camera to a CVBS monitor using the video preview output
( C ).

Loosen the locking screws ( D ), ( E ), ( G ) and ( J , see Fig. 5-5).

Adjust the camera and lens using the 3-axis mount (see Fig. 5-3).

Adjust the focal length and focus.

Check the video image on the CVBS monitor.

Fix the locking screws ( D ), ( E ), ( G ) and ( J , see Fig. 5-5).

Press and hold the selector ( B ) for approx. 2 seconds to open the OSD configuration
menu. Configure the camera settings.

Disconnect the video preview CVBS monitor.

Assemble the trim ring (with bubble) to the housing and tighten the 3 housing screws
(T20 Torx).
Fig. 6-7
WARNING
Danger of injury from camera falling down!
Ensure that the camera housing and the trim ring are securely
mounted!
Housing screw
(T20 Torx)
Bubble
Trim ring