MEGAROLL
26
Wheels
When changing the wheels, gloves that are approved for pressurised grease must be
used, if exposure to such is likely.
The wheel bearing must be lubricated and adjusted once a year. Also, ensure that tyres are inflated to
the correct pressure (see tyres). Adjustment and lubrication of wheel bearings
1.
Remove the hub cap.
2.
Remove the cotter pin.
3.
Tighten the castellated nut with a 1/6 turn, so that the hole is aligned with the shaft. Spin the wheel
around; there should be no resistance. Only a little bit of slack should be felt in the hub housing when
the wheel is moved from side to side. If there is too much slack, repeat the process.
4.
Install the cotter pin.
5.
Fill the hub cap ¾ with grease and refit
Hydraulics
All hydraulic hoses must be checked for wear and tear or damage. Ensure the hoses
are not subjected to any crushing.
If left parked for longer periods of time, the protruding plunger rods should be greased
with oil or pressure grease, in order to prevent the build-up of rust on the plunger
rods. Remember to remove the oil or grease again before use.
Summary of Contents for MEGAROLL 2130
