MEGAROLL
22
Maintenance
Good maintenance ensures a long life for the MEGAROLL and therefore optimal use of the machine.
Grease nipples have therefore been installed in places where the wear is greatest.
All screw connections must be tightened after the first day of work. Cotter pins and
bolts should be checked to avoid mechanical failure. The hydraulic system should also
be checked to ensure it is air-tight.
Lubrication
During lubrication of the machine, gloves that are approved for pressurised grease
must be used.
It is important that the machine is lubricated at the specified intervals to prevent unnecessary wear
and tear on moving parts.
In the lubrication table below, where it is written, for example, "3 x 2", this means that there are three
grease nipples on each side of the machine. Thus, there are six grease nipples in total at this location.
The lubrication points are specified on the following 2 pages.
Lubrication points
Number of
grease
nipples
Lubrication
interval [hours]
Images
Outermost side section
3 x 2
8
A
Hydraulic outermost side section, hydraulic weight
distribution and slewing ring (fifth wheel)
11 x 2
8
B
Pendle arms on the middle side section and
hydraulic stone protection for these
8 x 2
8
C
Tilt cylinders
4
8
D
Break hubs and bogie suspension
7 x 2
8
E
Wheel bearings
2
200
F
Rear roller suspension and mid-frame
assembly
8
8
G
Unfolding cylinders and suspension of side frames
6 x 2
8
H
All lubrication points should be greased at least once a year.
Summary of Contents for MEGAROLL 2130
