MAXIROLL
Page 35
Fitting axles with roller rings
1.
Position axles with roller rings and bearings corresponding to that when
MAXIROLL is extended, resting on the ground.
2.
Extend roller and carefully lower over the axles.
3.
Fit bolts (A)
Ensure no personnel are within the machine's extension radius when activating
hydraulics.
Do not activate hydraulics if there are personnel within machine extension radius.
Replacing axles, bearings or roller rings
Fig. 33
1.
Slacken bearing screws (A) and
withdraw bearings
2.
Slacken stop ring bolts (B) and
withdraw stop rings.
3.
Withdraw roller rings from axle
4.
Reverse order to reassemble
5.
Apply Loctite to bearing screws
Crosskill ring
Fig. 104
Note axle direction of rotation.
1.
After the outer stop ring (
Fig. B) there is a smaller ring.
3.
Fit bushing (A)
4.
Fit large ring (B)
5.
Finish off with a small ring, and
then fit a stop ring.
Tromle midt
B
A
B
A
Summary of Contents for MAXIROLL 1030
