DALBO MAXIDISC, Manual, Page: 8 / 38

MAXIDISC
Side 8
•
Never allow bystanders within the operating radius of the MAXIDISC when the hydrau-
lic system is activated to prevent individuals from the danger of being crushed.
•
Before performing maintenance or repairs on the hydraulic system, lower the imple-
ment to the ground, relieve pressure in the system, turn off the engine and remove the
ignition key.
•
Clean the hydraulic fittings thoroughly before connection. Ensure that the pressure is
relieved in the hydraulic system before connecting the hydrau
lic hoses to the tractor’s
hydraulic services.
•
After making repairs to the hydraulic system, thoroughly bleed air out of the system.
•
Regularly check hydraulic hoses for defects such as cracks, bends, chafing or leaks.
Replace defective hoses immediately.
•
Avoid spilling oil on the ground. In case of spills, collect the oil and dispose of it proper-
ly.
•
In case skin should come in contact with hydraulic oil or grease or in case clothing
should become stained with oil, remove the stained clothes immediately and wash the
affected skin areas thoroughly. Oil and grease are harmful to the skin.
•
Escaping hydraulic oil under high pressure can penetrate the skin and cause severe
injury. If an accident occurs, see a doctor immediately.
Hitching
•
An individual is in danger of being crushed during the hitching process. Never place
yourself or anyone else between the tractor and the MAXIDISC, or between parts that
must be attached or connected.
Maintenance and Repairs
•
Before servicing or making adjustments to the machine, securely block or unfold the
machine, engage the tractor and machine brakes, turn off the engine and remove the
ignition key.
•
Tighten all nuts, bolts hydraulic fittings or any other fastened assemblies after a few
hours’ use. Check often to make sure that they remain tho roughly tightened. Inspect
all pins, screws and bolts for wear or damage and make sure that all are securely in
place to avoid any possible damage or breakdown of the machine.
•
Dispose of oil, grease and filters according to applicable environmental regulations.
Transport
•
All safety and warning signs and devices required by law must be displayed,
mounted and tested for public road use. The driver is responsible for the cor-
rect use of lights and markings in compliance with the present Traffic Act and
Highway Code of the local traffic legislation.