DALBO CULTIMAX 650, Manual

Page: 23 / 26

CULTIMAX
Side 23
Fig. 15
9. Relieve the pressure in the cylin-
ders. Disconnect the hoses.
10. Remove the split pins and the oth-
er pins. The cylinders are now free.
11. Install new and repaired cylinders.
Remember to make sure, that the
pin is engaged in the stop and that
the pins are secured with split
pins.
12. Connect the hoses. After connec-
tion, make sure that there is no
danger of the hoses becoming
ripped off or pinched.
When mounted activate the cylinders a few times to outer-positions.
Replacing Wheel Bearings
Fig. 16
1. Remove the hub cap pos. 21.
2. Remove the split pin pos. 20.
3. Remove the castle nut pos. 19.
4. Pull off the hub housing pos.
22.
5. Remove the bearings pos
17+18.
6. Remove the seal ring pos. 16.
Mounting
1. Mount the outer collar from the bearings pos. 17+18 in hub housing pos. 22.
2. Mount the seal ring pos. 16.
3. Mount the inner collar from the bearing pos. 18 on the shaft pos. 2 and
mount the shaft in the hub housing.
4. Mount the inner collar from the bearing pos. 17 on the shaft pos. 2
5. Mount the castle nut on the shaft pos. 2 while turning the hub cap pos 22.
Tighten the castle nut until the hub housing turns slowly. Then loosen the
castle nut a quarter of a round, or until the hub housing turns easily pos 22.