AXR-H
Page 27
Bearing Protectors
Bearing protectors can be mounted on the disc bearings if you wish to have extra
protection for the bearing housings. Bearing protectors are installed in the holes
that hold the bearings and replace the original bolts.
Mounting
Mounting of the bearing protectors must be carried out while the AXR-H is in the un-
folded position and is resting on the ground. Remove the bolts from one bearing at
a time and mount the bearing protector, then continue on to the next bearing. Be-
fore starting to dismount the bearings, make sure that the bearings are clean.
Fig. 21
F-iron cage roller
An F-iron cage roller can be mounted behind the packer roller to achieve additional
field finishing. The F-iron cage roller is constructed as a roller yet has a smaller di-
ameter than the packer roller. This reduced diameter provides a faster rotation,
thereby crushing clods more effectively. At the same time, it further packs the sur-
face soil for improved moisture conservation.
Mounting
Unfold the AXR-H and lower it onto the ground.
Fig. 22
1.
Attach the U-bolt (A) to the
toolbar frame.
2.
Mount (B) the middle sec-
tion.
3.
Mount the F-iron cage roller
and the stone releasers (C)
(see ”
Spare Parts
”).
Adjust the F-iron cage roller to allow a distance of approximately 30 mm between
the two toolbar frames.
Tighten all nuts and bolts after few hours’ use.
