Dal Zotto INSERTO 700 ELITE CRYSTAL, User Manual

Page: 50 / 160

6
1
2 3
4 5
6
1 2 3 4 5
OFF
22.5°C 14:10
6
2
2
2
6
6
6
6
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
6
2
50 ENGLISH
GENERAL MENU
GO BACK - EXIT
PARAMETER SCROLLING: NEXT (2) ; PREVIOUS (3)
MODIFY SETTINGS DATA: INCREASE (4); DECREASE (5)
CONFIRM - ACCESS MENU
IT IS FORBIDDEN TO USE THE APPLIANCE WITHOUT THE DIVIDER AND/
OR GLASS PROTECTION (SEE THE FIGURE TO THE SIDE).
ITS REMOVAL JEOPARDISES THE SAFETY OF THE PRODUCT AND
IMMEDIATELY VOIDS THE WARRANTY PERIOD.
IN THE EVENT OF WEAR OR DETERIORATION CONTACT THE ASSISTANCE
SERVICE TO REPLACE THE PART
(THE REPLACEMENT IS NOT COVERED BY THE PRODUCT WARRANTY
AS IT IS A PART SUBJECT TO WEAR).
BURN POT DIVIDER
GLASS PROTECTION
YEAR
MONTH
DATE
MINUTES
HOURS
DAY
REPEAT THE SAME STEPS FOR
THE OTHER 3 TIME SLOTS
SET PRG1
07°C
MONDAY PRG1...
ON-OFF
STOP PRG1
START PRG1
...SUNDAY PRG1
ON-OFF
CONFIRM
WITH KEY 6
DISPLAY
PELLETS
IN %
V1 AIR
TANGENTIAL
STAND BY
KEYS LOCKED
V2 AIR
DUCTING
RESET
IT,EN,FR,DE,ES,PT
ENABLE CHRONO
PROG. 1 - 2 - 3 - 4
ON/OFF
SET CLOCK
SET CHRONO
LANGUAGE
USER
TECHNICIAN SET
(QUALIFIED TECHNICIAN USE
ONLY)
ENABLE CHRONO
GENERAL WARNINGS
Advice to follow for the first start-ups of the product:
During the first hours of operation, there may be some smoke or
odours, but they are due to the normal “thermal break-in” process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Š
Ventilate the room well
Š If present, remove any majolica parts from the top of the
product
Š
Activate the product at the maximum power and temperature
Š
Avoid remaining in the room for a long time
Š Do not touch the surfaces of the product
Notes:
The process is completed after a few heating/cooling cycles.
Do not use for the combustion of elements or substances other than
those indicated in the manual.
Before turning on the product, it is necessary to perform the
following checks:
Š If it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
Š The pellet hopper must be completed loaded
Š
The combustion chamber and the burn pot must be clean
Š
Make sure that the fire holder, the ash pan and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Š
Check that the power cord is properly connected
Š
The bipolar switch (if present) must be set to position “1”.