Mechanical Installation
5
To attach the tables together, follow the steps below:
1�
Look at the back side of the tables to determine the section numbering. Section
numbers are applied to the back of each table at the locations shown in
The farthest right table (when viewed from the rear) will typically be labeled “101”,
then the next table to its left will be “102”, and so on.
2�
Position the two sections close together as shown in
.
Note:
At this point, ensure the flip latches are not sticking out the side of the tables
prior to sliding the tables together, as this may damage the latches.
3�
Slide the sections together as shown in
.
Section
number
labels
Figure 5:
Section Number Label Locations
Figure 6:
Positioning Sections Together
Slide tables together
Figure 7:
Sliding Sections Together