Troubleshooting
21
4�
Remove the defective amplifier:
a�
Use a #2 screwdriver to remove the machine screws securing the amplifier.
b�
Carefully pull out on the amplifier, taking care not to break any cables inside the
cabinet. A flathead screwdriver may be needed to pry the amplifier loose.
c�
Unplug all power and signal cables.
d�
Unplug the 6-pin connector from the rear of the amplifier.
5�
Install the new amplifier:
a�
Verify existing weather stripping is present. If not, install new weather stripping.
b�
Verify all wires are still connected to the 6-pin connector and plug it into the rear
of the amplifier.
c�
Reconnect all power and signal cables.
d�
Position the amplifier and use a #2 screwdriver to reinstall the machine screws.
6�
Follow the
Sportsound Amplifier Field Guide (DD3318172)
to verify that the correct
firmware has been loaded by Daktronics Customer Service. All amplifiers present
should have the firmware verified and updated to the most current version available.
7�
to verify replacement amplifier is working correctly.
Media Converters
In standard audio systems, there are two media converter/network switches, one in the
fiber box and one in the control enclosure, that transfer digital audio signal. Looking at
the connections and LED indicators on these devices help with system troubleshooting.
Note:
These devices are not used in analog-only systems.
Typical Component Settings
• Ensure power is connected to green terminal block (Red to V1+, Black to V1-) and
the two BSP DIP switches are both set to ON. Refer to
•
Verify fiber cables are connected to RX and TX. Refer to
.
• Verify Ethernet cable connection(s) from other equipment. Typical connections for
standard systems are as follows:
• Fiber Conversion Box: 1 connection to ADC1; see
•
Control Enclosure: 1 or 2 connections for amplifiers (varies per audio system)
Figure 32:
Power & BSP Switches
Figure 33:
LED Indicators & Signal Connections
Summary of Contents for SPORTSOUND 500HD
