Daktronics OMNISPORT 2000, Operation Manual

Page: 133 / 182

Track Mode Operation
123
a� With the timer reset, press [EDIT] . This reveals the EDIT-START menu and puts the
time-of-day of the last start impulse on the LCD.
b� Confirm that the time-of-day shown on the LCD is the correct time for the start of
the race. The start time may be edited using the number keys.
c� Press [ENTER] . This completes the editing operation. The race clock will start and
the running time will be correct based on the entered start time.
Timer Operations After Race
This section describes operations that must take place after an event has completed.
Doing these operations will increase the effectiveness of accurate timing and help ease
the flow of running a large track meet.
Store Print
If an error is observed on the printout, press [EDIT] . Press [STORE PRINT] to verify the
correction. After all corrections are made, press [RESET]>[ENTER] . Refer to Print Menu
(p.127) . The timer is now ready to begin the next event. Advance to the next event or
heat and continue, following Pre-race Setup for the Timer Operator (p.121) and Timer
Operation During Race (p.122) through each race.
Printouts from the Built-in Printer
This section illustrates typical printouts from the OmniSport 2000 console. To create a
printout from the console’s built-in printer, refer to Print Menu (p.127) .
Track Configurations
It is important to save the printout ( Figure 62 ) for system settings to reuse for future meets.
The basis of the settings is letting the console know how the physical track and timer are
configured.
Figure 62: Track Settings