Daktronics Galaxy AF-3080 Series, Display Manual

Page: 40 / 107

6. Connect the cable to the temperature sensor terminal block on the controller
(TB7) per the following table:
Wire Color Terminal Bock TB7
(Temp In)
Pin 1 (+5V)
Pin 2 (GND)
Pin 3 (Light +)
Pin 4 (Light -)
Green Pin 5 (Temp +)
White Pin 6 (Temp -)
Red Pin 7 (+5V)
Black and Shield Pin 8 (GND)
Or Bare (Shield) Pin 8 (GND)
Figure 33: Temperature Sensor Wiring to Two Displays
To connect the temperature sensor to multiple displays (such as a double-face
display):
Wire Color Display 1 TB7 Display 2 TB7
Green Pin 5 (Temp +) Pin 5 (Temp +)
White Pin 6 (Temp -) Pin 6 (Temp -)
Red NC NC
Black NC NC
Note: GND and +5V (Red and Black) are connected from the temperature sensor to
the first display only. The Red and Black wires must not be connected between
controllers in additional displays .
Electrical Installation
3-16