Daktronics FUELIGHT FL-3000 Series, Installation Quick Manual

Page: 3 / 4

Fuelight
TM
FL-3000 and FL-4500 Petroleum
Display Installation Quick Guide
DD2238842
Rev 08
06 February 2019 201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Page 3 of 4
6. Route the provided line-to-line cable from the host driver jack J9 to the next client display driver,
connecting to jack J10. Refer to
Figure 9 .
7. Run cable through the
knockouts located on the
display’s backsheet and be
sure to use the provided cable
bushings that snap into place.
8. Repeat until all displays are
connected.
Note: Do not connect the last
display driver back to
the host.
Additional Information
Important Notes:
• Route cables at least 6 inches
away from interfering sources
like ballasts, florescent light
bulbs, power sources, any type of motor, etc.
• Pull excess cable into the display cabinet, coil cable, zip tie it together and carefully place coil
inside the display cabinet.
For additional support information or communications installation information, visit www.daktronics.com/
support .
Installing a Cash/Credit Display
A rectangular opening must be provided to accommodate the Cash/
Credit™ display. Consult the shop drawing for cutout dimensions.
1. Lift displays into the support structure. Figure 10 shows a display being
inserted into a support structure.
Note: Daktronics assumes no liability for display damage or injury
resulting from incorrect setup or incorrect lifting methods.
2. Drill through the front flanges of the cabinet to attach the display to
the base structure using appropriate hardware for site conditions.
Refer to Figure 11 . Actual site demands will dictate variances and
appropriate mounting methods.
Access Internal Cash/Credit Display Components
The door of Cash/Credit displays is secured by a screw (two screws
secure the door on 2H displays).
1. Use a Phillips-head screwdriver to loosen the screw.
2. Open the door using the knob attached to the display face.
Face 2 Face 1
Price 1
Price 2
Price 1
Price 2
Host Driver - Comm Attached
J10 - Line In
J9 - Line Out
J16 - Comm Port
LINE TO LINE
COMM
PORT
Figure 9: Line-to-Line Cable Installation
CORNER GAS
REG
DSL
UNL
Figure 10: Inserting Display Into
Cabinet
Figure 11: Secure Display in Sign
Structure