6
Mechanical Installation
Clamping Angles
This mounting method may be used to mount a scoreboard to I-beams or any beam/pole that
does not have flanges.
Mounting hardware includes rear clamping angles;
1
/
2
-13 x 24" threaded rods; and
1
/
2
" nuts,
flat washers, and lock washers. Refer to
Drawing A-1048184
in
Appendix B
.
Note:
The threaded rods do not pass through the beams; they run along both sides.
1.
Screw a threaded rod into each of the spring nuts as far as it will go.
2.
Position a scoreboard section at the front of the beams with the threaded rods
extending from the rear of the spring nuts, straddling the beams.
3.
Lift the scoreboard section to the desired height.
4.
Slide clamping angles over the ends of the rods and loosely install the washers and nuts.
5.
Make final adjustments in the positioning of the scoreboard section to ensure it is
flush and level, and firmly tighten all of the
1
/
2
" hex nuts.
6.
Repeat steps 1-5 for all scoreboard sections.
Mounting Tubes
This mounting method may be used to mount a scoreboard to horizontal beams. The
mounting tubes are attached to the scoreboard using spring nuts and
1
/
2
" hardware as
described above; this may be done during manufacturing or on-site. Refer to
Drawing A-1048268
in
Appendix B
for mounting tube assembly. The clip angles can be
adjusted vertically before they are bolted or welded to the horizontal beams. Recommended
attachment method and positioning of display pieces are provided in site-specific diagrams.
Figure 7:
Clamping Angle Mounting Method, Side View
