Daktronics 4200 Series, Installation Manual

Page: 19 / 39

15
Section Splicing Section Splicing
15. Loosen the nuts that hold the vertical splice
tube in place. Refer to
Figure 12.
16. Slide the vertical splice tube until centered
between the display sections.
17. Tighten the vertical splice tube nuts to secure
the splice tube in place.
18. Repeat Steps 15 - 18 for all vertical splice tubes.
19. Locate the border splice plate. Slide the splice
plates over the bolts on the top and bottom
border section splice opening on each end of the
display.
20. Complete the steps in Section 3 to install the
billboard.
21. Connect the signal splice cables, located in the
spare parts box, from the display top section
Signal A on the bottom section to Signal A on
the top section and Signal B on the bottom
section to Signal B on the top section. Refer to
Figure 13.
22. Connect the power splice cable, located in the
spare parts box, to the power interconnect jacks
on each display section.
23. Remove the yellow control equipment location sticker from
the back of the display.
Note: For displays that require a horizontal splice, refer to
the
Daktronics Digital Billboard Horizontal Power Splice
quick guide in
Appendix A for signal and power splicing
instructions.
Splice
Splice T
ube
Back of
Display
Nut Access
Hole
Splice T
ube
Back of
Display
Top of Bottom Section
Shipped Position
Installed Position
After Splice
Figure 12: Aligning and Installing the Vertical
Splice Tubes
Signal A
Signal B
Power
Interconnect
Figure 13: Power and Signal Splice
Connections