Manual # 650371E
4a. To optionally use the stock turn signal arrows, do not wire the turn signals to the VHX control box. Instead,
use the two provided two-wire harnesses. The harnesses plug directly into connectors on the back side of
your new VHX system. Connect the wires from these harnesses to your turn signal circuit and ground as
shown below. Doing this will light green LED bulbs, located in the original locations of your dash panel, when
turn signals are active. Make sure to check left and right to verify they are wired correctly.
VHX system (top side view)
WHITE / BLACK
Connect to
CHASSIS GND
WHITE / GREEN
Connect to
LEFT
turn circuit
WHITE / BLACK
Connect to
CHASSIS GND
WHITE / GREEN
Connect to
RIGHT
turn circuit
LEFT connector
RIGHT connector
