Manual # 650423A
5. Begin with the speedometer installation, located in
the left side opening in the factory dash. Cut three
pieces of the supplied foam tape,
2” long. Install
foam strips on the top and sides of each opening
about ½” down from the face of the housing. This
foam provides a cushion for the new VHX cans
and forms a tight, rattle-free fit.
6. The speed gauge has two CAT5 ports on the back side. Connect
the 24” CAT5 cable to either
port and one of the
36” CAT5 cables to the other port.
7. Remove the protective lens tape and insert the VHX
speedometer
into the
left
side of the factory
housing. You will need to fold the CAT5 cables and route them through the opening where the
original indicator lights were mounted in order to get the VHX bezel to sit flush with the housing.
As the gauge goes in, route the CAT5 cables through the opening in the bottom of the housing,
keeping in mind the
24” cable needs to be routed to the other side where it will connect to the
tachometer.
Foam Tape
Pre-bend cables to the side
before installing so unit will sit
flush once inserted into dash
Cable routed through
indicator light opening
Summary of Contents for VHX-69C-CAC
Page 8: ...Manual 650423A ...
