Manual # 650367
VHX system (top side view)
WHITE / BLACK
Connect to
CHASSIS GND
WHITE / GREEN
Connect to
LEFT
turn circuit
WHITE / BLACK
Connect to
CHASSIS GND
WHITE / GREEN
Connect to
RIGHT
turn circuit
LEFT connector
RIGHT connector
5. This system comes with the option to use two sets of turn signals in your dash: arrows located in the
faceplate of your new VHX display, and arrows in your vehicle’s stock turn signal locations. To use the
new faceplate arrows, follow the wiring instructions for the turn signals found in the main VHX manual.
To optionally use the stock turn signal arrows, do not wire the turn signals to the VHX control box.
Instead, use the two (2) provided two-wire harnesses. The harnesses plug directly into connectors on the
back side of your new VHX system. Connect the wires from these harnesses to your turn signal circuits
and ground as shown below. Doing this will light green LED bulbs, located in the original locations of
your dash panel, when turn signals are active. Make sure to check left and right to verify they were wired
correctly.
4. Secure the VHX system to the bezel using the four factory screws.
Summary of Contents for VHX-64C-CVL
Page 38: ...MAN 650314 D 34...
