Manual # 650800
Installation
1. Remove the stock gauge cluster from the dash. Retain all factory hardware for reassembly. Locations
of hardware to remove are shown by the red arrows.
2. Remove the bezel from the stock gauge cluster by removing the eight (8) screws shown in blue
arrows. Also remove and retain all gauge panel switches shown in red arrows. Switches will vary
by vehicle options.
3. Remove the A/C heater control unit from its mounted location. Attach the included #10-32 screws
to the A/C heater control unit. Viewing from the rear of the system, the
7/8” screw goes on the left
side, and the 1/2” screw will go on the right. Secure these screws with the two included #10-32
flange nuts and #10 lock washers.
