650066
10
SW 1 or Speed switch
The SW 1 terminal is used for selecting the various speed, distance, and performance
displays and also for entering the setup menu. The SW 1 input is activated by a ground
connection. The push button switch supplied (or any normally open switch) is wired by
connecting one terminal to SW 1 and the other terminal to a ground. When the button is
pressed and released, the speed message display will change. When the button is pressed and
held for a few seconds, any re-settable information displayed will be zeroed. On systems with
two message displays the one below the speed is dedicated to speed/performance messages.
On systems with one message display the speed/performance and rpm/warn messages will use
the same display.
SW 2 or Tach switch
The SW 2 terminal is used for selecting the various rpm, engine, and warning displays
and also for entering the demonstration mode. The SW 2 input is activated by a ground
connection. The push button switch supplied (or any normally open switch) is wired by
connecting one terminal to SW 2 and the other terminal to a ground. When the button is
pressed and released, the tach message display will change. When the button is pressed and
held for a few seconds, any re-settable information displayed will be zeroed. On systems with
two message displays the one below the tach is dedicated to rpm/warn messages. On systems
with one message display the speed/performance and rpm/warn messages will use the same
display.
To enter DEMO mode, press and hold the switch while turning the key on.
MESSAGE DISPLAYS
On systems with two message displays, switch 1 will toggle between the speed message
displays and switch 2 will toggle between the tach message displays.
On systems with one message displays, switch 1 will either switch from the tach
message to the speed message or toggle to the next speed message. Switch 2 will either
switch from the speed message to the tach message or toggle to the next tach message.
Speed message displays
DESCRIPTION .
ODOMTR
odometer mileage (0-999,999)
TRIP
trip odometer mileage (0-999.9)
SERVIC
miles since last service (0-9,999)
0-60 T
0-60 mph time in seconds (0-25.5)
HI SPD
high speed recall (0-255)
QUARTR
¼ mile time in seconds (0-25.5)
QT MPH
end of ¼ mile speed (0-255)
KPH xxx
kph conversion (or mph conversion if metric)
Tach Message displays
DESCRIPTION .
HI RPM
high rpm recall (0-18,000)
RPM-WN
rpm warning point (displays “SHIFT” when exceeded)
ENGINE
check engine indicator
BRAKE
brake warning indicator
4 WD
4 wheel drive indication
WAIT
diesel wait to start indicator
GEAR
gear shift position indicator
HOURS
hours system has been on with tach signal (0-999.9)
BAR (on systems with no bar graph)
bar tach readout on message display (0-8)
RPM (on systems with no digital tach)
digital tach readout on message display
TACH (on systems with no digital tach) digital tach readout on speed display
Summary of Contents for RET
Page 13: ...650066 11 ...
